The smoothness problem
ZM modeling problem
- Franch88
- MM2X Admin
- Posts: 15759
- Registered for: 17 years
- Location: Italy
- Been thanked: 1 time
- Contact:
With the Q key can be switch the flat shading 3D view mode. But, the issue is pretty easy to understand, it's about the model vertices, not connected between them. Maybe split manually each polygon and then unite them all would fix the issue. Also, export the model in .3ds and then re-importing it would fix the problem, but the quality should be worse becasue of normals problems.
Fiat 500 = Italian motorization. Franch88, MM2 eXtreme forum and website Administrator.
|Franch88's MM2 Releases|
|Franch88's MM2 Releases|
thx all
but it is not work yet
here is the link of the aircraft
https://www.sendspace.com/file/b5g30m
i hope you can solve the problem.
but it is not work yet
here is the link of the aircraft
https://www.sendspace.com/file/b5g30m
i hope you can solve the problem.
- RacingFreak
- MM2X Very Active User
- Posts: 1061
- Registered for: 13 years 8 months
- Location: Taiwan
i had export and import to 3ds many timesIt`s because you need to manual smooth the object. Using Zmodeler 1 export as .3ds and then import again (as Franch right suggested). Or if doesn`t work, use Zmodeler2 to smoothe the surface.
but it also not work
in zm2
By steven_03 at 2011-01-23
it like good and work after i press the smooth botton
but when i export to .3ds or old z3d file
and import to zm1.07b
the problem hadn't solved
By steven_03 at 2011-01-23